Wrench 4 Holley fuel inlet fitting 26-26 & float adjuster +2 gaskets like 26-102

Description

Are you tired of not having an easy way to tighten the fuel inlet fitting on your Holley 2 or 4 barrel carburetor?  I was too, especially when working on a set of tri-power carbs that are really close together.  Being as I stamp parts out for a living, I decided to do something about it.
This is a wrench that I designed for tightening the fuel inlet fitting on one end and adjusting the float level on the other end.  These are precision stamped out of cold rolled steel and nickel chrome plated to prevent rust and corrosion.  Both ends are 12 point (not 6 point like the others), so you can use them without any aggravation when needing a fine adjustment.  They are especially nice when working on a tri-power set of Holley carbs.
These completely surround the inlet fitting as shown.  The 4 pictures in a row show the different positions the wrench can be used when tightening the inlet fitting.  The float end should be self explanatory.
Along with the wrench I will send you a set of 7/8 nylon fuel inlet gaskets like the Holley 26-102's free of charge, or you can buy them separately at a reasonable cost.  No need to pay 10 bucks anymore for a set of them.
NOTE:  If you are using aftermarket fuel inlet fittings other than genuine Holley this wrench probably will not work as the outside corners are sharper, which makes the outside radius larger in diameter on the aftermarket ones.
I'm also going to offer a 1 year unconditional warranty.  If you ever have a problem or break one just send it back and I'll replace it with a brand new one free of charge.
I tried to list them with the shipping charge at 4 bucks no matter how many you buy, but with the revision page as it is, there's no way to do it that I can figure out.  If you buy more than one I will refund you any shipping over the 4 bucks.
One last thing, these are proudly made in the USA from US cold rolled steel.
Thanks,  Jerry